The water disposal demand of the water park takes into account the different shapes, sizes and depths of recreational, fitness and water playing equipment in various water waters, so the disposal volume is large. When planning and designing the water park, the water demand and the water cycle filtration cycle need to be taken into account. The water volume of each area is different. When planning and selecting water disposal equipment, Consider the influence of factors such as equipment disposal water volume and cycle period.
The purpose of water treatment and recycling purification of the water park is to remove suspended substances, colloids, bacteria, viruses brought by swimmers in the pool water and air, as well as dust, sediment, insects in the air, and equipment pollution: pollution caused by filter media, pipes, and valves. The water disposal steps of the water park are as follows: pool water circulation, including circulating water pump, water distribution and return system in the pool, etc; Pool water filtration, including pretreatment filtration, main filtration, flocculation auxiliary filtration, etc; Pool water disinfection, including water quality balance, etc.
Solution to water quality problems in the water park: after the newly used water park is full of water, 5kg copper sulfate per thousand cubic meters of water shall be put into the pool, and the next step of treatment shall be stopped after 24 hours. Add disinfectant; The disinfectant shall be 3-5 kg per thousand cubic meters of water (double for new water), and the circulating pump shall be pulled out and started evenly when dispensing. The residual chlorine shall be detected two hours later. If the residual chlorine is lower than 0.5 ppm, 1 kg (referring to per thousand cubic meters of water) disinfectant shall be added.
Add edible sodium carbonate to adjust the PH value of water park water 4 If the water is turbid or colored, and the turbidity of the water fails to meet the specification, polyaluminum chloride shall be added for adsorption treatment; It can be fed through the dosing pump. If you want to solve the problem quickly, you can directly add the pool water treatment solution in the pool water, and the dosage is 5-8KG of 1000 cubic meters of water. When adding polyaluminum, first use 10 times of water to dissolve and dilute the polyaluminum, start the circulating pump, pull the water spoon on the surface of the pool water on average, recycle for 1-2 hours after spraying, and then stop the circulation, and then suck the pool after 8 hours of inactivity.
